Women's waterproof windproof sailing anorak 100 - dark grey
Store Availability
Store availability
BENEFITS
Water repellent
Specially treated so water slides off the fabric's surface.
Resistance to salt water
Materials and zips resistant to salt water and sea air.
Windproof
Fabric specially coated to reduce the cooling effect of the wind.
Waterproof
Validated under 2 hours of moderate rain 2000mm Schmerber Pocket not waterproof
Pockets
3 secure pockets. (1 inner and 2 outer).
Breathability
Very breathable coated fabric (RET < 12): reduces condensation
TECHNICAL INFORMATIONS
WATERPROOFING 1/2
We measure the resistance to water pressure expressed in mm of water column (based on ISO 811 standard). The higher the water pressure withstood by the fabric, the more waterproof it is.
Here are the waterproofing ratings:
Component resistant to water pressure of 2000 mm before and after ageing (5 washes). This equates to 2000 Schmerber - average pressure exerted by the water during rain.
The jacket's waterproofing has been tested in a rain shower with 60 litres of water / m² / hour for 2 hours
WATERPROOFING 2/2
- Semi-high neck
- Injection-moulded plastic zip to avoid salt oxidation
- Water-repellent components (water runs off the fabric)
- 100% waterproofed seams
- Central opening features with a flap with a drainage channel for optimal waterproofing
POCKETS
Two zip pockets on the front of the jacket to put your hands or a few items
One inside pocket on the right side of the chest closed with a rip tab
NOTE: the pockets are NOT WATERPROOF
FRONT ZIP FASTENER
A zip on the entire jacket length with an interior flap protects against the wind and water.
Soft fabric flap on the top of the collar to protect the chin.
BREATHABILITY
To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric's resistance, the more moisture is evaporated, and therefore the higher the fabric's breathability.
We consider that if:
RET < 9 = highly breathable fabric
9 < RET < 12 = breathable fabric
The RET of the Sailing 100 anorak is 12.
WATER-REPELLENCE INFORMATION
A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.
Your anorak does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in activity these properties can be altered.
The water-repellent properties can be reactivated by putting the anorak in a drier for 10 minutes at the lowest temperature.
HOW TO WASH YOUR ANORAK?
To maintain the water repellent properties, infrequent washing is recommended.
Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full rinse cycle or extra rinse.
COMPOSITION
composition
Main fabric: 100.0% Polyamide; Main lining: 100.0% Polyester; Secondary lining: 100.0% Polyamide; Wristband: 2.0% Elastane, 98.0% Polyester; Yoke: 100.0% Polyester
Tips for storage and maintenance
MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.
BLEACHING EXCLUDED.
DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.
DO NOT IRON.
DO NOT DRY CLEAN.
TESTS AND WARRANTY
Warranty
2 Years
Agree by
Anorak tested and approved by our intermediate race testers!