Race 100 Men's boat regatta Anorak - black
Store Availability
Store availability
BENEFITS
Lightweight
650 g.
Resistance to salt water
Injected plastic zip.
Waterproof
Validated in a simulator reproducing MODERATE RAIN conditions
Pockets
3 secure pockets. (2 inner and 1 outer).
Breathability
Very breathable coated fabric (RET < 12).
TECHNICAL INFORMATIONS
WATERPROOFING
- Coated fabric
- A moderate rain corresponds to a flow of 60L/m2/h - (= rainfall of 60mm/h)
- The rainfall simulator reproduces these conditions for 2 hours.
- Component resistant to water pressure of 2000mm after ageing (= 2000 Schmerber - average pressure of water during a downpour)
- Water repellent components (water runs off the fabric).
- 100% taped seams.
- Central opening features a flap with a drainage channel for optimal waterproofing
BREATHABILITY
RET <12: very breathable.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.
RESISTANCE TO WEAR
- Injected plastic central zip resistant to salt oxidation.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY? step 1: before washing
Close all zips and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY? step 2: washing
You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.
Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY? step 3: drying
Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.
Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round.
How to reactive the jacket's water repellency?
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a spray sold in our stores.
COMPOSITION
composition
Main fabric: 100.0% Polyamide; Main lining: 100.0% Polyester; Secondary lining: 100.0% Polyamide; Wristband: 2.0% Elastane, 98.0% Polyester; Yoke: 100.0% Polyester
Tips for storage and maintenance
MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.
BLEACHING EXCLUDED.
DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.
DO NOT IRON.
DO NOT DRY CLEAN.
TESTS AND WARRANTY
Warranty
2 Years
Agree by
Anorak tested and approved by our intermediate race testers!