Babies Skiing/Sledging Suit Xwarm Pull'n Fit

PULL’N FIT

The innovative PULL'N FIT concept to easily adjust the length of the legs and sleeves on your baby's suit. With PULL'N FIT, the suit grows with your baby across 2 sizes.

Warmth

Our designers use padding and a special lining to keep the body warm. These polyester-based synthetic components trap more or less air depending on how thick they are. Consequently, the thicker the component (padding or lining), the more air it contains and the more insulating it is.

Component waterproofing

The resistance of a fabric to water pressure is expressed in terms of the height in mm of a water column that can be supported by the fabric (test based on the ISO 811 standard). The higher the pressure, the more waterproof the fabric. Components with a 2000 mm rating can withstand the pressure of a 2000 mm column of water (which is equivalent to a rain shower lasting 2 hours).

Waterproofing of the garment

This garment has been validated in a shower test under 60 L/sqm/hour of water for 4 hours. This test reproduces the average conditions under a snowstorm.

Water-repellent property of the component

The water-repellent property of a fabric is its ability to enable water to run off its surface without absorbing it. This prevents the fabric from absorbing water so that it stays lightweight, breathable and warm. The water-repellent property is obtained by applying a treatment to the outer surface of the fabric. This treatment needs to be restored during the lifetime of the garment (every 3 washes).

How to restore the water-repellent properties?

To reactivate the water-repellent property, wash the garment inside out on a synthetic cycle at 86°F and rinse thoroughly. You can use your usual detergent but no fabric softener. Then leave your jacket to air dry completely on a drying rack. Finally, turn your garment the right way around and put it in the tumble dryer on low heat for 10 minutes. The heat will reactivate the water-repellent property of the fabric.

How can I stop snow from entering my boots?

Put the elastic of the pants over the boot to prevent snow and drafts from getting inside the boot and pants.

How to dress your babies so they stay warm on your sledging outings?

In order to keep warm and dry, we recommend using the 3-layer rule: Layer 1 or second skin, to stay dry. Layer 2 or insulating layer, to retain the heat. Layer 3 or protective layer, to protect from the weather conditions.

Customization

A space to enter your child's name in order to personalize the product. A practical feature to find your ski suit at the crèche.