WOMEN’S SLOPE SKIS ADIX 500

Construction

Shellfiber Tec: made with a composite core, fiberglass casing from blade to blade for good pressure transfer. Light 3D in tip and heel, improving the torsion for optimized curve navigation (H-construction).

Bindings

Tyrolia bindings, SLR 9, model, Full Diagonal triggering for safety, DIN 2.5 to 9.

Durability

Structured and reinforced tip end and topsheet. Topsheet structurer for better durability.

Preparation

Waxed and sharpened skis, ready to use. Blade sharpened to 89°.

What is a camber?

When you set the ski on the ground, the points of contact between the ski and the ground are situated near to the tip and the heel, while the ski’s center (under the bindings) is slightly raised (this is the camber). The longer and higher the camber, the more grip and tension there is in the ski. The lower the camber, the more relaxed and maneuverable the ski.

What is a rocker?

On a “rocker” ski, the tip, and sometimes the heel, raise from the ground much faster than in a cambered ski. The effect of this is to move the points of contact towards the center of the ski. The ski surface area in contact with the snow is therefore reduced: you benefit from greater maneuverability and lift in smooth snow. On increasing the angle, you will come onto the length of the edge for more grip on hard snow. The longer the rocker, the more maneuverable your ski.

Piste rocker

Small tipped rocker eases the approach to turns.

Sidecut

124/70/108 in 163 cm, radius = 11.5 m

Versatility

90% slope-carving, 10% all snow slopes.

Available sizes

Sizes sold in-store: 149cm, 156cm. Sizes which can only be ordered online and at in-store terminals : 163 cm.